# 1-800-352-4776
 
Home >

SunSetter Topflight Tube #3 Button Replace Part FP020-1

SunSetter TopFlight Replacement Flagpole Parts

freeship.jpg

Assorted replacement parts for your SunSetter Topflight Telescoping Flagpole.  When you look for places to buy American flags or flagpole parts, Flagpro has the best selection and you can rest assured that all of our outdoor American flags for sale are made in the U.S.A. 

Tools Needed:

  • Phillips Screwdriver

    Parts Supplied:
  • FP020-1 Tube #3 Spring Button Assembly
  • Mounting screw



1. Remove the top sections of the pole by holding in the middle button while extending the section upwards and sliding the top two sections out of tube #3. 

2. Remove tube #3 from tube #4 by first lifting tube #3 until the button locks. Next, depress the button and remove tube #3 completely out of tube #4. 

3. Remove the two bottom end cap screws and remove the bottom cap. 

4. Remove the screw located next to the spring button. Depress the spring button into the tube assembly if it is not already depressed. 

5. Position the pole vertically so that the spring button is at the bottom. Drop a screwdriver, handle first, down the inside of the pole to knock the button assembly out. 

6. Install the new button assembly into the bottom end of the pole, flat side first. Be sure the groove in the button assembly is aligned with the track inside the tube. Use a long screwdriver to maneuver the button into its resting-place, with the button popping out of the hole. 

7. IMPORTANT: Reinstall the assembly mounting screw. 

8. Reinstall the bottom end cap with the two mounting screws. 

9. Place tube #3 back into tube #4. Lower it slowly until the button pops out of the hole in tube #4. Be sure to line up the slot in the bottom cap with the track on the inside of the tube. 

10. Place tube #’s 1 and 2 back into tube #3. Lower them slowly until the button pops out of the hole in tube #3. Be sure to line up the slot in the bottom cap with the track on the inside of the tube. 

11. Test the flagpole for proper operation. The button should automatically pop into the hole as you raise the section.

Specifications:

Tube #3 Spring Button Assembly

Part Number FP020-1

Item Number: FP020-1
$15.00
Quantity:

Reviewer: Paul
Rating: 5 out of 5
Review title: Perfect
Review contents: The Sunsetter part I ordered cost less with Flagpro than Sunsetter. I was pleased to see that it was a genuine Sunsetter part, and it was the correct replacement part. Order arrived quickly. Happy!